series ame2-njz 2 watt | ac-dc / dc-dc converter www.aimtec.com tel: +1 514 620 2722 toll free: + 1 888 9 aimtec (924 6832) f 052e r8 1 of 3 north america only features: picture coming soon models single output model input voltage (vac/hz) input voltage (vdc) temperature range (oc) output voltage (v) output current max (ma) maximum capacitive load (f) efficiency (%) 230 vac ame2-5snjz 165-264/47-63 233-370 -40 to +70 5 400 3000 70 AME2-12SNJZ 165-264/47-63 233-370 -40 to +70 12 167 1000 76 ame2-24snjz 165-264/47-63 233-370 -40 to +70 24 83 220 78 input specifications parameters conditions typical maximum units current (full load) 165 vac 30 ma 230 vac 25 ma inrush current <2ms (cold start) 165 vac 6 a 230 vac 10 a leakage current 230vac/50hz, rms 0.1 ma external fuse recommended slow blow type 2 a output specifications parameters conditions typical maximum units voltage accuracy full load 2 % line regulation ll-hl, full load 1 % load regulation 10% - 100% load, nominal input 1 % minimum load 10 % ripple & noise 20mhz bandwidth 50 150 mv p-p hold up time 165vac 230vac 8 16 ms isolation specifications parameters conditions typical rated units tested i/o voltage 60 sec 3000 vac isolation resistance >1000 m ? general specifications parameters conditions typical maximum units switching frequency 115 khz over current protection auto recovery 110 % of iout short circuit protection hiccup, auto recovery, continuous operating temperature* no derating -40 to +70 c storage temperature -40 to +105 c temperature coefficient 0.01 %/c maximum case temperature 100 c humidity non condensing 95 % rh case material plastic resin (flammability to ul 94v-0) weight 25 g cooling free air convection dimensions (l x w x h) 1.46 x 0. 96 x 0.71 (37.00 x 24.50 x 18.00mm) mtbf > 300,000 hrs (mil-hdbk -217f, t=+25oc)/full load note: all specifications in this datasheet are measured at an ambient temperature of 25c, humidity<75%, nominal input voltage and at rated output load unless otherwise specified. * sufficient air space around is needed. ? i/o isolation 3000vac ? ? operating temp: -40 c to +70 c ? input: 165-264vac, 47-63hz, or 233-370 vdc ? no internal electrolytic capacitors ? longer product life ? 0.3w ? continuous short circuit protection ? over current protection click on series name for product info on aimtec.com
series ame2-njz 2 watt | ac-dc / dc-dc converter www.aimtec.com tel: +1 514 620 2722 toll free: + 1 888 9 aimtec (924 6832) f 052e r8 2 of 3 north america only safety specifications parameters standards information technology equipment iec/en/ul 60950-1 emi - conducted and radiated emission en55022, class b electrostatic discharge immunity iec 61000-4-2, contact:6kv/air:8kv, criteria b rf, electromagnetic field immunity iec 61000-4-3, 10v/m, criteria a electrical fast transient/burst immunity iec 61000-4-4, 2kv, criteria b, with application circuit surge immunity(1kv) iec 61000-4-5, 1kv/2kv, criteria b, with application circuit rf, conducted disturbance immunity iec 61000-4-6, 10vrms, criteria a power frequency magnetic field immuni ty iec 61000-4-8, 10a/m, criteria a voltage dips, short interruptions immunity iec 61000-4-11, 0-70%, criteria b pin out specifications dimensions application circuit for vin: 165-264vac *gnd connection not allowed pin single 1 ac input (l) 3 ac input (n) 14 -v output 16 +v output 20 +v cap 22 -v cap ac dc ac ? l ac ? n + ? vout \? vout single ? output fuse 1a/250v c1 1f/50v ac ? l ac ? n \? vout ??? c2 + tvs + ? vout 20 22 5.08 (0.20) 24.50 (0.97) 5.08 (0.20) printed face 18.00 (0.71) 4.10 (0.16) 0.60 (0.02) 17.78 (0.70) 37.00 (1.46) all dimensions are typical: millimeters (inches) pin diameter: 0.60 0.10 (0.02 0.004) case tolerance: 0.5 (0.02) bottom view 1 3 20 14 16 22 5.08 (0.20) 10.16 (0.40)
series ame2-njz 2 watt | ac-dc / dc-dc converter www.aimtec.com tel: +1 514 620 2722 toll free: + 1 888 9 aimtec (924 6832) f 052e r8 3 of 3 north america only application circuit for vin: 85-264vac *gnd connection not allowed note: 1. datasheets are updated as needed and as such, specifications ar e subject to change without notic e. once printed or downloaded , datasheets are no longer controlled by aimtec; refer to www.aimtec.com for the most current product specifications. 2. product labels shown, including safety agency ce rtifications on labels, may vary based on the date manufactured. 3. mechanical drawings and specifications are for reference only. 4. all specifications are measured at an ambient temperature of 25c, humidity<75%, nominal input voltage and at rated output load unless otherwise specifie d. 5. aimtec may not have conducted destructive testin g or chemical analysis on all internal components and chemicals at the time of publishing this document. cas numbers and other limited information are considered proprietary an d may not be available for release. 6. this product is not designed for use in critical life support systems, equipment used in hazardous environments, nuclear control sys tems or other such applications which necessitate specific safety and regulatory standards ot her the ones listed in this datasheet. 7. warranty is in accordance with aimtec?s st andard terms of sale available at www.aimtec.com. model c2 c3 tvs 5 vout 100 f / 35v 4.7 f / 400v 7v 12 vout 68 f / 35v 20v 24 vout 47 f / 35v 30v ac dc ac ? l ac ? n + ? vout \? vout single ? output fuse 1a/250v c1 1f/50v ac ? l ac ? n \? vout ??? c2 + tvs + ? vout 20 22 + ??? c3
|
